CLICK PICTURE TO DOWNLOAD BAG TEMPLATE
CLICK PICTURE TO DOWNLOAD
BAG APPLIQUES
BAG APPLIQUES
7. PUT YOUR LITERATURE IN THE BAG AND HANG FROM RADIO KNOB OR HEATER CONTROL LEVER
6. GLUE OR DOUBLE FACE TAPE THE APPLIQUES TO THE BAG OVER THE ONES SHOWING THROUGH
THE NEW BAG
THE NEW BAG
5. PRINT OUT THE BAG TEMPLATE (BELOW) PLACE YOUR BAG OVER THE TEMPLATE LINING UP THE TOP AT THE TOP OF THE PAGE AND LEFT SIDE ON THE RULER
3. FOLD BAG IN HALF AND USING A X-ACTO KNIFE CUT AROUND A QUARTER TO PUT A 1" CIRCULAR HOLE 1/2" DOWN FROM THE TOP CENTER FLAP OF THE BAG
2. CUT THE TOP DOWN IN THE FRONT 2.25"
TO MAKE YOUR OWN REPRODUCTION BAG FOLLOW THE DIRECTIONS BELOW
A WHILE BACK I FOUND ALL THE ORIGINAL FACTORY PAPERWORK AND LITURATURE THAT CAME WITH
MY NEW 1978 MERCURY ZEPHYR.
I DECIDED TO RECREATE THE PAMPHLET AND BAG FOR SHOWS.
THE PAMPHLETS WERE EASY. JUST SCAN, PRINT AND FOLD.
THE BAG WAS A LITTLE MORE OF A CHALLENGE. I HAVE NOT FOUND A BAG THE SAME SIZE YET. IN THE MEANTIME I FASHIONED ONE OUT OF A CLEAR LARGER BAG. CUTTING IT
DOWN TO SIZE AND GLUING THE OPEN EDGE. IT IS NOT AS THICK AS THE ORIGINAL, AND IS TOO TRANSLUCENT.
BUT WILL HAVE TO DO UNTIL I STUMBLE
ACROSS A BETTER SOLUTION.
MY NEW 1978 MERCURY ZEPHYR.
I DECIDED TO RECREATE THE PAMPHLET AND BAG FOR SHOWS.
THE PAMPHLETS WERE EASY. JUST SCAN, PRINT AND FOLD.
THE BAG WAS A LITTLE MORE OF A CHALLENGE. I HAVE NOT FOUND A BAG THE SAME SIZE YET. IN THE MEANTIME I FASHIONED ONE OUT OF A CLEAR LARGER BAG. CUTTING IT
DOWN TO SIZE AND GLUING THE OPEN EDGE. IT IS NOT AS THICK AS THE ORIGINAL, AND IS TOO TRANSLUCENT.
BUT WILL HAVE TO DO UNTIL I STUMBLE
ACROSS A BETTER SOLUTION.
MAKE A REPRODUCTION FORD LITTER BAG
4. PRINT OUT THE BAG APPLIQUE
(BELOW) AND CUT THEM
OUT AS INSTRUCTED
(BELOW) AND CUT THEM
OUT AS INSTRUCTED
1. FIND A CLEAR PLASTIC BAG 11.5
X 6.5" IN SIZE. IF YOU CANNOT
FIND ONE, YOU CAN CUT
A LARGER BAG DOWN TO SIZE
AND GLUE THE SIDE SHUT
X 6.5" IN SIZE. IF YOU CANNOT
FIND ONE, YOU CAN CUT
A LARGER BAG DOWN TO SIZE
AND GLUE THE SIDE SHUT
