MAKE YOUR OWN "FROM THE FACTORY" VISOR SLEEVE!
Create the sleeve on your word processor. The outer box is 10"X6".
Click the image above to download a PDF of the text and pictures you need.
Most of the fonts are Arial. Type the text in and adjust the size to fit.
Then print it out on regular paper.
Cut the sides of the 2 pages a little bigger than the box.
Cut the top and bottom of the "Starting Instructions" leaving them an inch longer than the box.
Wrap the "Starting" part around the visor and mark the bottom edge where the "Seat Belt Instructions" will be glued.
Cut the top of the "Seat Belt" to fit the area.
Glue the top edge of the "Seat Belt" to the bottom edge of the "Starting".
After it dries, wrap it around the visor and measure the bottom edge of the "Seat Belt".
Mark and trim edge. Put back around visor and glue.
It should be loose enough to silde on and off easily.
Cut the top and bottom of the "Starting Instructions" leaving them an inch longer than the box.
Wrap the "Starting" part around the visor and mark the bottom edge where the "Seat Belt Instructions" will be glued.
Cut the top of the "Seat Belt" to fit the area.
Glue the top edge of the "Seat Belt" to the bottom edge of the "Starting".
After it dries, wrap it around the visor and measure the bottom edge of the "Seat Belt".
Mark and trim edge. Put back around visor and glue.
It should be loose enough to silde on and off easily.
